10.1
The Environmental Monitoring and Audit
(EM&A) Report presents the EM&A works undertaken in May 2013 in accordance with
EM&A Manual.
10.2 No
Action/Limit Level exceedance was recorded for air
quality
and water quality.
10.3
One Action Level exceedance
was recorded for noise as one documented complaint was received to complaint the noise nuisance due to loading of metal
parts at barge near the seawall of Works Area WA6 early morning (around 8:45a.m)
on 18 May 2013 (Saturday) in the reporting month. No Limit Level exceedance for noise was recorded.
10.4 Environmental
site inspection was conducted on 7th,
14th, 21st and 31st May 2013 by ET in the reporting month. All deficiencies identified during the site
inspection have already rectified / improved during the follow-up audit
session.
10.5 There
were three environmental
complaints,
no notification
of summons and successful prosecution received.
10.6 The
ET will keep track on the EM&A programme to
ensure compliance of environmental requirements and the proper implementation
of all necessary mitigation measures.
10.7 According
to the environmental audit performed in the reporting month, the following recommendations were made:
Air Quality Impact
¡¤
To
regularly maintain the quality of machinery and vehicles on site.
¡¤
To
implement dust suppression measures on all haul roads, stockpiles, dry surfaces
and excavation works.
¡¤
To provide hoarding along the entire length of that portion of the site boundary.
Noise Impact
¡¤
To
inspect the noise sources inside the site.
¡¤
To space
out noisy equipment and position the equipment as far away as possible from
sensitive receivers.
¡¤
To
provide temporary noise barriers for operations of noisy equipment near the
noise sensitive receivers, if necessary.
Water Impact
¡¤
To prevent any surface runoff discharge into any
stream course and sea.
¡¤
To review and implement temporary drainage
system.
¡¤
To identify any wastewater discharges from site.
¡¤
To ensure properly maintenance for de-silting
facilities.
¡¤
To clear the silt and sediment in the
sedimentation tanks.
¡¤
To review the capacity of de-silting facilities
for discharge.
¡¤
To divert all the water generated from
construction site to de-silting facilities with enough handling capacity before
discharge.
¡¤
To avoid accumulation of stagnant and ponding water on site.
Waste/Chemical Management
¡¤
To check
for any accumulation of waste materials or rubbish on site.
¡¤
To ensure the performance of sorting of C&D
materials at source (during generation);
¡¤
To carry out inspection of dump truck at site exit
to ensure inert and non-inert C&D materials are properly segregated before
removing off site.
¡¤
To avoid
any discharge or accidental spillage of
chemical waste or oil directly from the site.
¡¤
To avoid
improper handling or storage of oil drum on site.